汽车用离合器面片—旋转爆裂强度试验Clutch facings for automobiles—rotating burst strength test
一、试片
取外观质量无缺陷的完整面片6片作为试样,其中3个试样进行常温试验,3个进行高温试验。
Take 6 pieces of complete dough sheets with no defects in appearance quality as samples, of which 3 samples are subjected to normal temperature test and 3 are subjected to high temperature test.
二、实验设备
旋转爆裂强度试验设备,其性能要求如下:
—— 最大转速可达到2000rpm,最大角加速度可达到300rpm/s
—— 主轴旋转时无振动,转速误差小于1%,角加速度误差小于3%
—— 测速表分度值不大于1转
—— 最高试验温度可达到300℃,控温精度未±2℃
—— 能自动记录试片在旋转爆裂时的转速
The performance requirements of the rotating burst strength test equipment are as follows:
—— The maximum speed can reach 2000rpm, and the maximum angular acceleration can reach 300rpm/s.
—— There is no vibration when the spindle rotates, the speed error is less than 1%, and the angular acceleration error is less than 3%.
—— Speedometer division value is not more than 1 revolution.
—— The highest test temperature can reach 300℃, and the temperature control accuracy is less than ±2℃.
—— It can automatically record the rotation speed of the test piece when it is rotating and bursting.
三、标准
GB/T5764-2011
相关设备:CF-R 系列 离合器面片旋转强度试验机
上一篇 Previous:国家专用汽车车载装置产品检验中心采购我公司设备安装调试完毕
下一篇 Next:产品亮点:四级过滤的制样机